Here is how to use LED face masks so the light reaches your skin and your eyes stay protected. Start on clean, dry, bare skin, run one session, then put on your skincare. Most masks run 9 to 20 minutes, 2 to 5 times a week. Give the routine 8 to 12 weeks before you judge it.
We did not wear or test these masks. We read the owner's manuals, FDA 510(k) files, brand product pages and published trials, then compared their instructions step by step.
Wash and fully dry your face, protect your eyes, and wear the LED mask on bare skin for the time your manual sets, usually 9 to 20 minutes. Apply serum and moisturizer afterward. Use it 2 to 5 times a week, at most once a day, and judge results after 8 to 12 weeks.
Still choosing a mask? See our best LED face masks.
How to use LED face masks, step by step
The CurrentBody, Therabody and Renpho manuals agree on the basic order. These seven steps cover every LED face mask in this guide.
- Do a sensitivity test first. CurrentBody asks for one full session on your arm, hand or inner thigh, then a 24-hour wait. Renpho runs the first Artemis session at brightness level 1, then asks you to watch your skin for at least 10 hours.
- Cleanse and dry your face. Remove makeup, sunscreen and any product with acids. Renpho notes that these can affect light output.
- Protect your eyes. Fit the eye shields or eye cups that came with the mask, or keep your eyes closed.
- Fit the straps. Adjust them so the mask stays in place for the whole session.
- Start the program. Most masks run a preset session and switch off on their own.
- Apply your skincare. Serum and moisturizer go on after the session.
- Wipe the mask. All four brands ask you to wipe it clean, and CurrentBody and Therabody say after every use.

Should you use an LED mask before or after skincare?
Use the LED mask first, then your skincare. The CurrentBody Series 2 manual says to start with skin free of products and to apply skincare after the session. It warns that other products can irritate skin or block the light.
The TheraFace Mask manual also starts with "a clean, dry face." Renpho's Artemis manual asks you to remove cosmetics with chemical or acidic ingredients before you begin.
One exception: CurrentBody's product page suggests its own Green Tea Serum before sessions, while the manual says bare skin. If you want to pair them, ask CurrentBody which instruction applies to you.
How long and how often should you use an LED mask?
Follow your own mask's schedule, because light strength differs between brands. The four masks here range from 9 to 20 minutes, 2 to 5 times a week.
- CurrentBody Series 2: 10 minutes, 3 to 5 times a week, and no more than one session on the same area within 24 hours.
- Therabody TheraFace Mask: a 9-minute program, 2 to 5 times a week in its K230293 FDA file.
- Renpho Artemis: 10 minutes, 3 to 4 times a week, dropping to 1 to 2 once you see results.
- LumyHealth 4D: 15 to 20 minutes, 3 to 5 times a week.
More sessions do not mean faster results. A 2025 trial in 95 women found two red-light sessions a week worked about as well as three.
How long until you see results from an LED face mask?
Plan on 8 to 12 weeks of steady use. In a 2025 sham-controlled trial of a home mask, wrinkle changes were measurable from week 8 but not at week 4.
Brand timelines vary. The CurrentBody manual mentions 4 weeks, its FDA summary describes a 6-week schedule, and its product page says 8 weeks. Therabody's own 12-week study reports changes from 8 weeks. Photos taken in the same light make slow changes easier to see.
How do you protect your eyes during an LED mask session?
Use the eye protection your mask comes with, every session. The American Academy of Dermatology advises against swapping in sunglasses for the protection a device recommends. For the full picture, see are LED face masks safe for your eyes.
- CurrentBody Series 2: position the mask so you see through the eye openings, and do not look straight into the light.
- TheraFace Mask: the eyeshield is optional. Without it, keep your eyes closed for the whole session.
- Renpho Artemis: fit the eye cups, since the mask also gives off infrared light.
Therabody notes that its eyeshield can leave mild redness around the eyes, which should fade within 5 to 10 minutes.
Settings for popular LED face masks
Here is how each mask's manual or product page sets up a session. Prices are from each brand's US store as of October 19, 2026.
| Mask | Session | How often | First-use test | FDA |
|---|---|---|---|---|
| CurrentBody Series 2 | 10 min, auto | 3-5 times a week | Full session on arm or hand, wait 24 h | K250966 |
| TheraFace Mask | 9 min (3 modes x 3 min) | 2-5 times a week | Not listed | K230293 |
| Renpho Artemis | 10 min default (10, 20 or 30) | 3-4 times a week, then 1-2 | Level 1, wait 10 h | K243555 |
| LumyHealth 4D | 15-20 min | 3-5 times a week | Not published | No 510(k) found |
CurrentBody Skin LED Mask Series 2
Best for: a simple one-button routine for fine lines. The CurrentBody Series 2 has a single power button and runs a fixed 10-minute session of red and near-infrared light. It is FDA cleared for full-face wrinkles under K250966.
Some LEDs can look dark during a session because near-infrared light is invisible. A full charge takes 4.5 hours, and the mask does not run while charging. It costs $469.99 as of October 19, 2026. Read more in our CurrentBody LED mask review.
We may earn a commission if you buy through the links below, at no extra cost to you.
See today's price at CurrentBodyTherabody TheraFace Mask
Best for: short sessions with wrinkle and acne light in one program. Hold the LED button for the automatic 9-minute program: red, then red plus infrared, then blue, 3 minutes each. A short press picks a single 3-minute mode.
The TheraFace Mask is FDA cleared under K230293 for full-face wrinkles and mild to moderate inflammatory acne. Therabody's manual names no best time of day, so pick a time you can repeat. It costs $649.99 as of October 19, 2026. Our TheraFace Mask review covers the study.
See today's price at TherabodyRenpho Artemis LED Mask
Best for: a budget mask with adjustable brightness. The Renpho Artemis offers a 10, 20 or 30-minute timer, with 10 recommended, and five brightness levels. Renpho suggests starting at level 1 and moving up gradually.
The Artemis E100B is FDA cleared under K243555: Mode 1 for full-face wrinkles, Modes 2 and 3 for mild to moderate inflammatory acne. Renpho's page lists a 2.5-hour charge, while the manual says about 3 to 4 hours. It costs $159.99 as of October 19, 2026.
See today's price at RenphoLumyHealth 4D Face & Neck Mask
Best for: covering the face and neck in one session. The LumyHealth 4D comes with separate face and neck masks and a wireless remote for mode, brightness and timer. LumyHealth's product page suggests 15 to 20 minutes, 3 to 5 times a week.
We found no FDA 510(k) for the LumyHealth 4D, so ask LumyHealth which clearance covers it. The box list does not include eye shields, so ask which eye protection to use. It costs $299 as of October 19, 2026.
See today's price at LumyHealthWho should not use an LED face mask without asking a doctor?
Each brand lists people who should skip LED masks or check with a doctor first. Across the CurrentBody, Therabody and Renpho warnings, that includes anyone who:
- takes medicines that make skin or eyes sensitive to light, including some antibiotics and retinoids
- has lupus, porphyria or another light-sensitive condition
- has had seizures triggered by light, or epilepsy
- has an eye condition such as glaucoma or cataracts, or recent eye surgery
- is pregnant, planning a pregnancy or breastfeeding
- uses retinol or benzoyl peroxide, since Therabody advises against its infrared light with both
- has had Botox, filler, microneedling, laser or a peel and the skin has not recovered
- has a darker skin tone, which the AAD links to a higher risk of dark spots from visible light
- has heart disease or an active cancer, both listed in at least one brand's warnings
Age rules differ. CurrentBody excludes children 12 and under, and Therabody asks for adult supervision under 18. Renpho does not recommend the Artemis for anyone under 22.
Renpho's product page also lists active acne among areas to avoid, though the Artemis clearance covers mild to moderate inflammatory acne. If you plan to use its acne modes, ask Renpho or a dermatologist first.
Common LED mask mistakes to avoid
- Wearing it over products. Makeup, sunscreen and acids sit between the light and your skin.
- Doubling up. CurrentBody says to wait 24 hours between sessions on the same area.
- Skipping the patch test. It takes up to a day and shows how your skin reacts.
- Going straight to full brightness. Renpho starts the Artemis at level 1 for a reason.
- Using it while charging. The CurrentBody, TheraFace and Artemis manuals say not to.
- Quitting at week 3. In the 2025 home-mask trial, changes showed from week 8.
To check whether a mask suits your goal, see do LED masks really work. To compare models, see our best LED face masks.
LED face mask FAQ
Do you put anything on your face before an LED mask?
No. Wear an LED mask on clean, dry, bare skin, then apply serum and moisturizer afterward. The CurrentBody manual says other products can irritate skin or block the light. Renpho asks you to remove cosmetics with acids first.
How often should you use an LED face mask?
Most LED face masks call for 2 to 5 sessions a week. CurrentBody suggests 3 to 5, the TheraFace Mask FDA file 2 to 5, and Renpho 3 to 4 for the Artemis. A 2025 trial found two sessions a week worked about as well as three.
Can you use an LED mask every day or twice a day?
Once a day at most. CurrentBody says not to repeat a session on the same area within 24 hours. Therabody's own 12-week study used the TheraFace Mask once a day. Twice a day is not in any manual we read.
What is the best time to use the TheraFace Mask?
Therabody's manual does not name a best time of day. Use the TheraFace Mask whenever you can repeat it, on a clean, dry face. Fitting it in after you wash your face, morning or evening, makes the routine easy to keep.
Can you use an LED mask with retinol?
Use the LED mask on bare skin and ask a dermatologist about timing if you use retinoids. Therabody advises against its infrared light if you use retinol or benzoyl peroxide. Renpho lists photosensitizing medicines, including retinoids, among reasons to check first.
Can you use an LED mask while pregnant?
Ask your doctor first. Renpho says not to use the Artemis during pregnancy, and CurrentBody's product page says the same. Therabody asks you to consult a physician if you are pregnant or nursing.
Sources
- FDA 510(k) database: K250966, CurrentBody Skin LED Light Therapy Mask Series 2 (decision June 25, 2025)
- FDA 510(k) database: K230293, Therabody TheraFace Mask (decision June 9, 2023)
- FDA 510(k) database: K243555, LED light therapy masks including Renpho Artemis E100B (decision February 5, 2025)
- Park et al., Medicine, 2025: home-used LED and infrared mask for crow's feet, randomized, double-blind, sham-controlled study
- Bragato et al., Lasers in Medical Science, 2025: photobiomodulation application frequency in facial rejuvenation
Show 8 more sources
- American Academy of Dermatology: Is red light therapy right for your skin?
- CurrentBody Skin LED Mask Series 2 user manual (PDF)
- CurrentBody: LED Red Light Therapy Face Mask Series 2 product page
- Therabody TheraFace Mask owner's manual (PDF, hosted by retailer Abt)
- Therabody precautions and contraindications
- Renpho Artemis E100B LED mask user manual (PDF)
- Renpho: Artemis LED Light Therapy Mask product page
- LumyHealth: 4D Rejuvenating Face & Neck Mask product page and FAQ